Filter
Top Products
7
Employer must enforce compliance with the safety warnings and all other
instructions contained in this manual.
Keep this manual available for use by all people assigned to use this tool.
For personal safety and proper operation of this tool, read and understand
tool labels and manual. Failure to follow warnings could result in DEATH or
SERIOUS INJURY. Read and follow all of these instructions carefully.
Delta Model DBN125 is designed to install 18 ga. brad nails of various
lengths from
3
/8" to 1
1
/4" long. Brad nails are loaded into the magazine from
the side.
Delta Model DBS125 is designed as a 2 in 1 tool to install 18 ga. brad nails of
various lengths from
3
/8" to 1
1
/4" long and narrow crown staples of various
lengths from
3
/8" to 1" long. Brad nails are loaded into the magazine from the
side and narrow crown staples are loaded into the magazine from the top.
Delta Model DNS100 is designed to install 18 ga. narrow crown staples of
various lengths from
3
/
8" to 1" long. Narrow crown staples are loaded into the
magazine from the top.
Delta ShopMaster nailing and stapling tools are compact, lightweight, high
performance tools designed for molding, interior trim, paneling, cabinetry,
picture/mirror frames and crafts. Features include jam release mechanism,
tool free adjustable exhaust and fastener depth adjustments, fastener reload
indicator, rubber grip, safety positioned on rear of nose and a removable
rubber nose cushion with on tool storage.
Use approved Delta fasteners only.
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated
pressures between 70 and 120 PSI (Pounds per Square Inch)
(4.8 to 8.3 BAR)
.
The preferred system would include a filter, a pressure regulator, and an
automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is
ideal.
All compressed air contains moisture and other contaminates that are
detrimental to internal components of the tool. An air line filter will remove
most of these contaminates and significantly prolong the life of the tool. If an
in-line oiler is not available: place five or six drops of Delta Air Tool Oil into the
tool’s air inlet at the beginning of each workday.
The tool is equipped with a
1
/
4" male “quick connector”. The tool must always
be connected to the air supply with a coupling such that all pressure is
removed from the tool when the coupling is disconnected.
EMPLOYER’S RESPONSIBILITIES
FUNCTIONAL DESCRIPTION