Filter
Top Products
9
Fig. 16
C
A
D
B
DISCONNECT THE MACHINE FROM THE
POWER SOURCE.
Fig. 15
To adjust the sliding fit between the movable table and the
base, turn the nut (A) Fig. 15 clockwise to tighten the fit
(counter-clockwise to loosen the fit). This adjustment
should not be so tight that it restricts the rotating movement
of the table, or so loose that it affects the accuracy of the
saw.
ADJUSTING SLIDING FIT BETWEEN MOVABLE TABLE AND BASE
ADJUSTING FENCE 90° TO BLADE
IMPORTANT: Before making this adjustment, set the
blade at 0° to the table. See section “Adjusting 0°,
33.9° and 45° bevel positive stops.”
A
DISCONNECT THE MACHINE FROM THE POWER SOURCE.
1. Place a framing square (E) Fig 16 on the table against the right fence (D). Rotate the movable table (A) Fig. 16 until
the blade (C) is 90° to the right fence.
2. Adjust the front miter scale (B) Fig. 16 so that 0° detent notch is engaged.
3. Adjust the miter curser (F) Fig. 17 so that the pointer is aligned with the 0° mark on the scale by loosening the screw
(G), adjusting the cursor (F), and tightening the screw (G).
4. Place one end of a framing square (A) Fig. 18 against the front of the right fence (B) and the other end against the
left fence base (C). Use the supplied wrench to loosen left fence base mounting screws (D) and adjust the left fence
base parallel to the right fence.
Fig. 18
Fig. 17
G
F
A
B
D
C
Fig. 21
A
A
TABLE HAZARD ZONE
The area inside the two red lines (A) Fig.
21 on the table is designated as a hazard zone. Never
place your hand(s) inside the "Table Hazard Zone"
(within the red lines) WHILE THE TOOL IS BEING
OPERATED. Clamp all workpieces which would
cause your hand(s) to be within the red lines.
E