Filter
Top Products
THE PLYWOOD BASE MUST BE
SECURED TO THE FLOOR OR SUPPORTING
SURFACE IF THERE IS ANY TENDENCY OF THE
DRILL PRESS TO VIBRATE, SLIDE OR WALK
DURING NORMAL OPERATION.
11
6. Assemble the column (A) Fig. 6, to the base (B) using
the four M10x40mm hex head screws (C), three of which
are shown.
Fig. 6
7. Assemble table raising and lowering handle (D) Fig.
7, to worm gear shaft (E) and tighten screw (F) against
flat on shaft with 3mm wrench supplied.
Fig. 7
Fig. 8
8. Thread table clamp handle (G) Fig. 8, into hole in
rear of table bracket, as shown.
D
E
F
G
C
C
A
B