Filter
Top Products
9
CARTON CONTENTS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
20
21
22
19
Fig. 2
1. Drill Press Head
2. Table
3. Table Bracket and Column
4. Light
5. Base
6. Chuck
7. Handle (3)
8. Spindle Adapter
9. Spindle Adapter Remover
10. 5mm Hex Wrench
11. 3mm Hex Wrench
12. Table Raising and Lowering Handle
13. Table Raising and Lowering Lock Lever
14. Table Lock Lever
15. Chuck Key
16. (2) M8x1.25x125mm carriage head screws, (4) flat
washers, (2) lockwashers, and (2) hex nuts (for
fastening drill press to a supporting surface)
17. M10x1.5x40mm Hex Head Screws (4)
18. M6x1x12mm Hex Cap Head Screw (2)
19. 1/4" Washer
20. Cord Strain Relief
21. Cord Clamp (2)
22. Cord Bushing
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from
all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,
gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household
floor paste wax.