Filter
Top Products
7
Employer must enforce compliance with the safety warnings and all other
instructions contained in this manual.
Keep this manual available for use by all people assigned to use this tool.
For personal safety and proper operation of this tool, read and understand
tool labels and manual. Failure to follow warnings could result in DEATH or
SERIOUS INJURY. Read and follow all of these instructions carefully.
Ex-Cell Model EBN125 is designed to install generic 18 ga. brad nails of
various lengths from
5
/8" to 1
1
/4" long. Brad nails are loaded into the
magazine from the side.
Ex-Cell Model EBN200 is designed to install generic 18 ga. brad nails of
various lengths from
5
/8" to 2" long. Brad nails are loaded into the magazine
from the side.
Ex-Cell nailing tools are compact, lightweight, high performance tools
designed for molding, interior trim, paneling, cabinetry, picture/mirror frames
and crafts. Features include jam release mechanism, tool free adjustable
exhaust, fastener reload indicator, safety positioned on rear of nose and
removable rubber nose cushion.
1) Brad Nailer 3) Air Tool Oil Bottle
2) Brad Nails 4) Owner's Manual
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated
pressures between 70 and 110 PSI (Pounds per Square Inch)
(4.8 to 7.6 BAR)
.
The preferred system would include a filter, a pressure regulator, and an
automatic oiler located as close to the tool as possible, within 15 ft/4.6 m is
ideal.
The tool is equipped with a
1
/4"
male “quick connector”.
All compressed air contains moisture and other contaminates that are
detrimental to internal components of the tool. An air line filter will remove
most of these contaminates and significantly prolong the life of the tool. If an
in-line oiler is not available: place five or six drops of Air Tool Oil into the tool’s
air inlet at the beginning of each workday.
EMPLOYER’S RESPONSIBILITIES
FUNCTIONAL DESCRIPTION
CARTON CONTENTS