Filter
Top Products
12
DUST COLLECTOR
Model 340 is supplied with a Dust Collector Assembly that is attached to
the sander as outlined below. An accessory hose assembly, is available to
connect the sander to a remote vacuum system.
Do not operate the sander without (A) the dust collector
installed, or (B) an appropriate vacuum system attached. Dust could be
blown into your eyes and the level of dust in the atmosphere would be
greatly increased.
TO INSTALL DUST COLLECTOR
DISCONNECT TOOL FROM POWER SOURCE.
1. Position dust collector (A) Fig. 11, to sander nozzle. Seat collector firmly
onto the nozzle, (B) Fig. 12.
2. Periodically remove the dust container (A) Fig. 13, from its mounting
flange (B), and empty the collected dust.
NOTE: A slight twisting action will ease removal and reassembly.
OPERATION
Fig. 9
Fig. 10
TO START AND STOP SANDER
Make certain the switch is in the “OFF” position, and the
power source is the same as that specified on the tool’s nameplate.
1. Connect the sander to the power
source.
2. Lift sander off the work and hold it
firmly when switching the motor
“ON” and “OFF”.
3. The switch button (A) Fig. 8, is
labeled “ON” and “OFF”. Depress
the “ON” end of the switch button
to start motor. Depress the “OFF”
end of the switch button to stop
motor.
HOW TO HOLD SANDER
Model 340 is designed to be held either around the housings, Fig. 9, or by
the top of the housings, Fig. 10. When sanding for long periods, it is
recommended you periodically alternate between the two holding positions.
A
Fig. 8