Filter
Top Products
Before operating jointer, check guard to
make sure it functions properly and
quickly returns to the closed position.
17
Fig. 34
Fig. 35
4. To adjust belt tension, turn nuts (F) and (G) Fig. 34, to
move motor plate (H) up or down until there is
approximately 1/2 inch deflection at the center span of the
belts, as explained in STEP 3.
ADJUSTING
SPRING TENSION OF
CUTTERHEAD GUARD
The cutterhead guard (A) Fig. 35, completely covers the
cutterhead. During operation the material being jointed or
planed pushes the guard (A) out of the way and at the
completion of the cut, the guard (A) springs back over the
cutterhead providing full coverage. If it ever becomes
necessary to adjust the spring tension of the cutterhead
guard (A), loosen two screws (B) and turn screw (C)
clockwise to increase or counterclockwise to decrease the
spring tension. Then tighten the two screws (B).
A
C
B
H
G
F