Filter
Top Products
8
CAUTION: Never remove safety grid for any reason
except to perform maintenance procedures. There is
a high speed blower wheel inside the blower housing
that can amputate fingers, grab loose clothing or
neckties. Make certain the dust collector is discon-
nected from the power source before performing any
maintenance procedures.
8. Place the entire blower and motor assembly (C)
Fig. 13, into collection drum (R) (not supplied).
Fig. 12
Fig. 13
Fig. 14
Fig. 15
W ARNING: The dust collector has a safety guard (P)
Fig. 14, at the blower housing of the dust collector,
which contains a high speed radial blade that can
amputate fingers, grab loose clothing and neckties,
or propel dust at high velocities. This guard is for
your safety. DO N O T REMOVETHIS GUARDFOR
ANY REASON!
9. Place the bag elbow (V) Fig. 14, over the dust dis -
charge port (T). Align three holes in bag elbow with three
mounting holes in dust discharge port (T) and fasten bag
elbow (V) to discharge port (T) with three sheet met al
screws (Y) Figs. 14 and 15, two of which are shown.
W
W
V
L
R
C
V
P
T
Y
Y