Filter
Top Products
INSTALLATION
4
Fig. 3
Fig. 4
Fig. 5
Fig. 6
DISCONNECT THE SAW FROM THE POWER SOURCE!
IMPORTANT: The following instructions for
assembling the splitter illustrated in this manual are
shown on a Delta 10” left-tilting arbor Unisaw.
Assembly to a right-tilting arbor saw will be opposite
to what is shown except where noted.
1. Locate the components shown in Fig. 2, for the splitter
assembly.
2. Insert and seat stud (A) Fig. 3 through hole in side of
splitter mounting bracket (B). NOTE: It will be necessary
to have a hammer, punch (C) and a tool with a recessed
hole similar to a deep well socket (D) in order to seat stud
(A) Fig. 3, and used as shown in Fig. 4.
3. Fig. 5 illustrates stud (A) assembled to splitter
mounting bracket for both the left and right tilting arbor
saw.
4. Loosely assemble plate (E) Fig. 6, knob (F), spring (G),
flat washer (H) and E-ring (J) onto stud (A) as shown
assembled in Fig. 7.
A
B
C
LEFT-TILT RIGHT-TILT
D
E F G H J
A
A