Filter
Top Products
Fig. 27
10
24. There is an adjustment screw to achieve the desired
weight of the guard basket (M) Fig. 27, on the workpiece.
To make an adjustment, loosen locknut (V) Fig. 26, and
turn wing nut (W) clockwise to decrease the pressure or
counter-clockwise to increase the pressure. After the
desired pressure is achieved, tighten locknut (V).
V
W
25. Front to back movement of the blade guard basket (N) Fig. 27, is obtained by loosening locking knob
(R) and sliding basket body arm (N) in or out as desired. Always tighten locking knob (R) after adjusment
is complete. NOTICE: IT IS RECOMMENED THAT THE BACK OF HOOD ASSEMBLY (M) BE
POSITIONED 3/8” IN FRONT OF THE SPLITTER BLADE.
Fig. 26
M
R
N