Filter
Top Products
English
1010
Troubleshooting Guide…
TROUBLE! TOOL VIBRATES EXCESSIVELY DURING CUT
WHAT’S WRONG? WHAT TO DO…
1. Tool not mounted securely to stand or work bench. 1. Tighten all mounting hardware. See page 8, Procedure for
Permanent Mounting.
2. Damaged wheel. 2. Replace wheel.
3. Workpiece not clamped properly. 3. Refer to Material Clamping and Supporting page 6.
TROUBLE! DOES NOT MAKE ACCURATE CUTS
WHAT’S WRONG? WHAT TO DO…
1. Fence not adjusted correctly. 1. Check and adjust. See Fence Operation on page 6.
2. Wheel is not square to fence. 2. Check and adjust.
3. Excessive force used to make cut. 3. Reduce cutting force, let the wheel do the work.
4. Work piece moving. 4. Clamp workpiece securely. See Material Clamping and
Supporting, page 6. Make sure material is laying flat against the
base.
TROUBLE! CANNOT MOVE ARM
WHAT’S WRONG? WHAT TO DO…
1. Lock down pin is engaged. 1. Push down slightly on the arm, pull down lock down pin and
raise arm.
TROUBLE! MATERIAL MOVES DURING CUT
WHAT’S WRONG? WHAT TO DO…
1. Fence slipping or workpiece incorrectly placed or clamped. 1. See Material Clamping and Supporting, page 6.
2. Vise too loose 2. Tighten vise clamping.
3. Excessive cutting force. 3. Reduce cutting force.