Filter
Top Products
English
33
CAUTION: Wear appropriate hearing protection during use.
Under some conditions and duration of use, noise from this
product may contribute to hearing loss.
CAUTION: Spark deflector will get hot. Avoid touching or adjusting
while hot. Keep cordset and materials away from spark deflector.
WARNING: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contains chemi-
cals known to the State of California to cause cancer, birth defects,
or other reproduc tive harm. Some examples of these chemicals
are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber
(CCA).
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals:
work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed
to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding,
sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or
lay on the skin may promote absorption of harmful chemicals.
WARNING: Always use NIOSH/OSHA approved respiratory
protection appropriate for the dust exposure. Direct particles away
from face and body.
For your convenience and safety, the following warnings are on
your Heavy-Duty 14" (355 mm) Chop Saw:
FOR SAFE OPERATION READ THE INSTRUCTION
MANUAL.
DO NOT USE TOOTHED BLADES.
USE ONLY REINFORCED WHEELS RATED 4100 RPM OR
HIGHER.
WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT
PARTS.
ALWAYS: WEAR EYE PROTECTION, USE GUARDS, CLAMP
WORK IN VISE, USE PROPER RESPIRATORY
PROTECTION.
DO NOT EXPOSE TO RAIN OR USE IN
DAMP LOCATIONS.
ONLY USE CHOP SAW WHEEL OF A MAX.
THICKNESS OF 3.1 mm AND A MAX.
DIAMETER OF 355 mm.
FEATURES (Fig. 1, 4)
A. Lock pin J. Wheel
B. Spark deflector screw K. Guard
C. Spark deflector L. Wheel lock lever
D. Base M. Depth stop bolt
E. Fence N. Trigger switch
F. Vise O. Padlock hole
G. 8 mm hex wrench P. Jam nut
H. Crank Q. Fence bolts
I. Vise lever
Power Supply
Be sure your power supply agrees with the nameplate marking.
A voltage decrease of more than 10% will cause a loss of power
and overheating.
Cutting Capacity
The wide vise opening and high pivot point provide cutting capacity
for many large pieces. Use the cutting capacity chart to determine
total maximum size of cuts that can be made with a new wheel.