Filter
Top Products
WARNING: For your own safety read instruction manual before
operating tool.
Grounding Instructions
In the event of a malfunction or breakdown, grounding provides a path
of least resistance for electric current to reduce the risk of electric
shock. This tool is equipped with an electric cord having an
equipment-grounding conductor and grounding plug. The plug must
be plugged into a matching outlet that is properly installed and
grounded in accordance with all local codes and ordinances. Do not
modify plug provided—if it will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. The conductor with insulation having
an outer surface that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or replacement of the
electric cord or plug is necessary, do not connect the equipment-
grounding conductor to a live terminal.
Check with a qualified electrician or service personnel if the grounding
instructions are not completely understood, or if in doubt as to
whether the tool is properly grounded.
Use only 3-wire extension cords that have 3-prong grounding plugs
and 3-pole receptacles that accept the tool’s plug.
Repair or replace damaged or worn cords immediately.
1
English
This tool is intended for use on a circuit that has an outlet that looks
like the one illustrated in Figure A. The tool has a grounding plug that
looks like the plug illustrated in Figure A. A temporary adapter, which
looks the adapter illustrated in Figures B and C, may be used to
connect this plug to a 2-pole receptacle as shown in Figure B if a
properly grounded outlet is not available. The temporary adapter
should be used only until a properly grounded outlet can be installed
by a qualified electrician. The green-colored rigid ear, lug, and the like,
extending from the adapter must be connected to a permanent
ground such as a properly grounded outlet box.
Important Safety Instructions
• KEEP GUARDS IN PLACE and in working order.
• KEEP WORK AREA CLEAN. Cluttered areas and benches invite
injuries.
• DON’T USE IN DANGEROUS ENVIRONMENT. Don’t use power
tools in damp or wet locations, or expose them to rain. Keep work
area well lighted.
• KEEP CHILDREN AWAY. All visitors should be kept safe distance
from work area.
• MAKE WORKSHOP KID PROOF with padlocks, master switches,
or by removing starter keys.
• DON’T FORCE TOOL. It will do the job better and safer at the rate
for which it was designed.
• USE RIGHT TOOL. Don’t force tool or attachment to do a job for
which it was not designed.
• USE PROPER EXTENSION CORD. Make sure your extension
cord is in good condition. When using and extension cord, be sure
to use one heavy enough to carry the current your product will draw.
An undersized cord will cause a drop in line voltage resulting in loss
of power and overheating. The following table shows the correct
size to use depending on cord length and nameplate ampere rating.
If in doubt, use the next heavier gage. The smaller the gage
number, the heavier the cord.
AB C
GROUNDING PIN
GROUNDED
OUTLET
BOX
GROUNDING
MEANS
ADAPTER
DW788/383329 8/6/02 10:35 AM Page 1