Filter
Top Products
9
English
2. Insert 1/4-20 screws down through the holes in the base and
through holes in mounting surface. The approximate length of
the screws should be the thickness of the mounting surface plus
4 inches.
CRADLE MOUNTING
1. Cut two boards approximately 20" long x 2" high x 4" wide.
2. Place tool at desired work location.
3. Place boards tightly along side, and attach to work surface,
(Figure 15).
Maintenance
Motor Brush Inspection and Replacement
(Fig. 16)
BE SURE TOOL IS UNPLUGGED BEFORE INSPECTING
BRUSHES. Brushes should be regularly inspected for wear. To
inspect brushes, unscrew the two end cap screws (A) and remove
end cap (B). To remove each brush, (C) first unplug the shunt wire
terminal connection. Then carefully back the brush spring (D) out of
the brush box and remove brush. Brushes should slide freely in brush
box. If brushes are worn down to .3” (8mm) (see Figure 17) they
should be replaced. To reinstall each brush carefully back the spring
out of the brush box, insert the brush and return the spring making
sure it is pressing on the brush and not touching the brush box.
Reconnect shunt wire terminal, then replace the end cap and two
screws.
Cleaning
Blowing dust and grit out of the main housing and chip deflector by
means of an air hose is recommended and should be done as often
as dirt is seen collecting in and around the air vents.
Accessories
Blades are available at extra cost from your local dealer or
authorized service center. If you need assistance in locating this
accessory for your tool, contact:
DEWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
21286
CAUTION: The use of any other accessory not recommended
for use with this tool could be hazardous.
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment other than those discussed in this manual should be
performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Lubrication
Closed-type, grease-sealed ball bearings are used throughout. These
bearings have sufficient lubrication packed in them at the factory to last
the life of the tool.
Gears should be relubricated every 60 to 90 days, depending upon
use. This lubrication should only be attempted by experienced power
tool repair persons like the mechanics at D
EWALT service centers. The
gear case should be wiped clean and 2 oz. (60 grams) of D
EWALT
Lubricant Part No. 790206 (6 oz. tube) placed in the gear case.
Full Warranty
D
EWALT heavy duty industrial tools are warranted for one year from
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information, call
1-800-4-D
EWALT. This warranty does not apply to accessories or
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, D
EWALT tools are covered by our:
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
392736-01,00,DW872 6/29/00 9:00 AM Page 9