Filter
Top Products
LED Worklight (Fig. 15)
The LED worklight (B) will activate when the trigger is depressed.
FIG. 15
B
Helpful Hints
• Always ensure the workpiece is firmly held or clamped to prevent
movement. Any movement of the material may affect the quality
of the cutting or sanding finish.
• Do not start sanding without having the sandpaper attached to
sanding platen.
• Use coarse grit paper to sand rough surfaces, medium grit
for smooth surfaces and fine grit for the finishing surfaces. If
necessary, first make a test run on scrap material.
• Excessive force will reduce the working efficiency and cause
motor overload. Replacing the accessory regularly will maintain
optimum working efficiency.
• Do not allow the sandpaper to wear away, it will damage the
sanding pad.
• If the tool overheats, especially when used at low speed, set the
speed to maximum and run it with no load for 2–3 minutes to cool
the motor. Avoid prolonged usage at very low speeds. Always
keep the blade sharp.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
Accessories
WARNING: Since accessories, other than those offered by
D
EWALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk of
injury, only D
EWALT recommended accessories should be used with
this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center. If
you need assistance in locating any accessory, please contact
D
EWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
21286, call 1-800-4-D
EWALT (1-800-433-9258) or visit our website:
www.dewalt.com.
English
8