Filter
Top Products
English
16
injury, ALWAYS wear ANSI Z87.1 safety glasses while using
compressed air.
WARNING: When cleaning, use only mild soap and a damp
cloth on plastic parts. Many household cleaners contain chemicals
which could seriously damage plastic. Also, do not use gasoline,
turpentine, lacquer or paint thinner, dry cleaning fluids or similar
products which may seriously damage plastic parts. Never let any
liquid get inside the tool; never immerse any part of the tool into a
liquid.
Lubrication
This tool has been lubricated with a sufficient amount of high grade
lubricant for the life of the unit under normal operating conditions.
No further lubrication is necessary.
Brushes
WARNING: To reduce the risk of injury, DO NOT TIE, TAPE, OR
OTHERWISE LOCK THE ON/OFF SWITCH ON while “running in”.
HOLD BY HAND ONLY.
Inspect carbon brushes regularly by unplugging tool, removing the
brush inspection cap and withdrawing the brush assembly. Keep
brushes clean and sliding freely in their guides. Always replace a used
brush in the same orientation in the holder as it was prior to removal.
Carbon brushes have varying symbols stamped into their sides, and if
the brushes are worn down to the line closest to the spring, they must
be replaced. Use only identical D
EWALT brushes. Always replace
both brushes. Use of the correct grade of brush is essential for proper
operation of electric brakes. New brush assemblies are available at
your local D
EWALT certified service center. The tool should be allowed
to “run in” (run at no load without blade) for 10 minutes before use to
seat new brushes. This is especially important for saws equipped with
electric brakes, which may be erratic in operation until the brushes are
properly seated (worn in).
Accessories
WARNING: Since accessories, other than those offered by
D
EWALT, have not been tested with this product, use of such
accessories with this tool could be hazardous. To reduce the risk
of injury, only D
EWALT, recommended accessories should be used
with this product.
WARNING: DO NOT USE WATER FEED ATTACHMENTS
WITH THIS SAW.
WARNING: VISUALLY EXAMINE CARBIDE BLADES BEFORE
USE. REPLACE IF DAMAGED.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If
you need assistance in locating any accessory, please contact
D
EWALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
21286, call 1-800-4-D
EWALT (1-800-433-9258) or visit our website
www.dewalt.com.
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement)
should be performed by a D
EWALT factory service center, a
D
EWALT authorized service center or other qualified service
personnel. Always use identical replacement parts.
Three Year Limited Warranty
DEWALT will repair, without charge, any defects due to faulty
materials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
EWALT (1-800-
433-9258). This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by others. This