Filter
Top Products
English
8
2. Set the bevel angle by tilting the saw shoe (D) until the mark
indicates the desired angle on the bevel scale (X).
3. Tighten the bevel adjustment knobs (E).
N
K
O
Q
P
R
2-3 mm
2-3 mm
FIG. 3
Adjusting the Riving Knife (Fig. 3)
For the correct adjustment of the riving knife (Q), refer to the Figure
3. Adjust the clearance of the riving knife after changing the saw
blade or whenever necessary.
1. Follow Changing the Saw Blade steps 1–4.
2. Loosen the riving adjustment screw (R) with an hex wrench (Z)
and set the riving knife as shown in Figure 3.
3. Tighten the riving knife screw (R).
4. Turn the lock lever (M) counterclockwise until it stops.
5. Move the track saw back to top position.
F
FIG. 4
Cutting Depth Adjustment (Fig. 4)
The cutting depth can be set at 0–2-5/16" (0–59 mm) without track
attached; with the track attached: 0–2-1/8" (0–55 mm).
1. Loosen the depth adjustment knob (F) and move the pointer to
obtain the correct depth of cut.
2. Tighten the depth adjustment knob (F).
NOTE: For optimal results, allow the saw blade to protrude from the
workpiece by about 1/8" (3 mm).
OPERATION
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing