Filter
Top Products
firm grip with both hands on the saw and position your body and
arm to allow you to resist kickback ff # occurs.
Figure 13 shows proper sawing position. Note that hands are kept
away from cutting area. To avoid kickback, DO support board or
panel NEAR the cut (Fig. 14). DON'T support board or panel away
from the cut (Fig. 15).
FIG. 14
DO support board or panel NEAR the cut.
SUPPORT
FIG. 15
DON'T support board or panel AWAY from the cut.
Place the work with its "good" side - the one on which appearance
is most important - down. The saw cuts upward, so any splintering
will be on the work face that is up when you cut it.
Cutting
_ WARNING: Never attempt to use this tool by resting it upside
down on a work surface and bringing the material to the tool.
Always securely clamp the workpiece and bring the tool to the
workpiece, securely holding the tool with two hands as shown in
Figure 13.
Place the wider portion of the saw foot plate on that part of the
work piece which is solidly supported, not on the section that will
fall off when the cut is made. As examples, Figure 13 illustrates the
RIGHT way to cut off the end of a board. Always clamp work. Don't
try to hold short pieces by hand! Remember to support cantilevered
and overhanging material. Use caution when sawing material from
below.
Be sure saw is up to full speed before blade contacts material to
be cut. Starting saw with blade against material to be cut or pushed
forward into kerf can result in kickback. Push the saw forward at a
speed which allows the blade to cut without laboring. Hardness and
toughness can vary even in the same piece of material, and knotty or
damp sections can put a heavy load on the saw. When this happens,
push the saw more slowly, but hard enough to keep working without
much decrease in speed. Forcing the saw can cause rough cuts,
inaccuracy, kickback, and over-heating of the motor. Should your cut
begin to go off the line, don't try to force it back on. Release the switch
and allow blade to come to a complete stop. Then you can withdraw
the saw, sight anew, and start a new cut slightly inside the wrong one.
In any event, withdraw the saw if you must shift the cut. Forcing a
correction inside the cut can stall the saw and lead to kickback.
13