Filter
Top Products
OPERATION AND USE (Cont’d.)
SLIP CLUTCH
If the drilling tool becomes jammed or gets
caught, the slip clutch releases.
Remove the load from the machine
immediately by pulling back the drilling
tool.
Always hold the machine tightly with both
hands and assume a secure stance.
Do not apply too much pressure. The
performance is not increased in this
manner.
SUPPLEMENTARY HANDGRIP
For reasons of safety, when working with this
type of electric power tool, the operator
should always use the adjustable handgrip.
In order to fit the handgrip on the drill,
loosen the threaded sleeve on the handgrip,
turning it in an anticlockwise direction.
Slide the handgrip onto the drill collar,
tilting it to the desired angle; tighten the
sleeve until it is securely attached to the
machine.
To fit the depth stop, loosen the threaded
sleeve on the handgrip, turning in an
anticlockwise direction. Insert the depth
stop into the adjustable handgrip collar,
position for the correct depth, then tighten
the sleeve until it is secure.
IMPROPER USE
The functions and use of this tool are those
exclusively indicated in this manual. ANY
OTHER USE OF THE TOOL IS
EXPLICITLY FORBIDDEN.
- 7 -