Filter
Top Products
MAINTENANCE &
PART REPLACEMENT
- 8 -
Regular inspection and cleaning reduces the
necessity for maintenance operations and will
keep your tool in good working condition.The
tool bearings and gears are life-long lubricated,
however it is advised to check the condition of the
grease in the head every 100 hours, if necessary
replace the grease.The motor must be correctly
ventilated during tool operation. For this reason
avoid blocking the air inlets with hands. After use
disconnect the tool from the power supply and
clean carefully, use compressed air through
ventilation slots.
DISPOSAL
At the end of the machine’s working life, or when
it can no longer be repaired,ensure that it is
disposed of according to the standard regulations
of the country in which it is being used, and that
the disposal operation is carried out by
specialized personnel following authorized
guidelines.
In all circumstances:
- Do not abandon in the environment;
- Do not dispose of together with solid urban
waste products;
- Contact the special recycling centres.
WARNING
Disconnect the plug from the power supply socket
before replacing any parts.
BRUSHES
The brushes must be replaced after approx. 150-
200 working hours, or if they are less then 5-6mm
in length.
WARNING
For correct tool operation always change the
brushes in pairs, not separately. The use of original
Draper spare parts is recommended.After having
fitted new brushes allow the motor to run for at
least five minutes without load for the brushes to
bed.
IMPORTANT:
This operation should only be performed by an
authorized person.
REPLACING THE POWER SUPPLY CABLE
Check that the power supply cable is in good
condition, if not have it replaced by an authorized
person.The machine is fitted with a safety
clutch.