Filter
Top Products
KICKBACK may occur. Investigate and take
corrective action to eliminate the cause of blade
binding. Wet lumber, green lumber or pressure-
treated lumber and most plastics require special
attention during cutting operation to prevent
KICKBACK. Avoid cutting nails. Inspect for and
remove all nails from lumber before cutting.
When restarting a saw in a workpiece, center
the saw blade in the kerf and check that saw
teeth are not engaged into the material. If saw
blade is binding,it may walk up or KICKBACK from
the workpiece as the tool is restarted.
Support panels to minimize the risk of blade
pinching and KICKBACK. Large panels tend to sag
under their own weight. Supports must be placed
under the panel on both sides,near the line of cut and
near the edge of the panel.
Do not use dull or damaged blade.Unsharpened
or improperly set blades produce narrow kerf
causing excessive friction, blade binding and
KICKBACK.
Use extra caution when making a “Pocket
Cut” into existing walls or other blind areas.
The protruding blade may cut objects that can
cause KICKBACK.
67
Symbols:
IMPORTANT: Some of the following symbols may
be used on your tool.Please study them and learn
their meaning. Proper interpretation of these
symbols will allow you to operate the tool better
and more safely.
Symbol Name Designation/Explanation
V Volts Voltage (potential)
A Amperes Current
Hz Hertz Frequency (cycles per second)
W Watt Power
kg Kilograms Weight
min Minutes Time
s Seconds Time
ø Diameter
Size of drill bits, grinding wheels, etc.
n
o
No load speed Rotational speed, at no load
.../min Revolutions or Revolutions, strokes, surface
reciprocation speed, orbits, etc. per minute
per/min.
O Off position Zero speed, zero torque...
1, 2, 3, ... Selector settings Speed, torque or position
I, II, III, settings. Higher number means
greater speed
o Infinitely variable Speed is increasing
selector with off from 0 setting
Arrow Action in the direction of arrow
Alternating current Type or a characteristic of current
Direct current Type or a characteristic of current
5716 Dremel 2.625x4.25 6/18/02 10:29 AM Page 6