Filter
Top Products
The paint runs
or sags?
Paint too diluted Add undiluted material
Paint volume Reduce the paint flow
too high by turning Fluid Adjusting Screw
Moving too slowly Increase speed of application
Spray gun trigger being Release trigger earlier
held for too long
Spray gun too close Increase the distance between
eceipkrow dna nug
Paint is thin or Paint too thick Add thinner
irregular Paint volume Increase the paint flow by turning
too low Fluid Adjusting Screw
Moving too fast Reduce speed of application
Spray gun clogged Clean the gun
Spray gun too far away Reduce the distance between
eceip krow dna nug
No spray pattern
Paint too thick Add thinner
Air Volume too low Set air volume control valve to max by
turning anti-clockwise
being produced
Gun clogged Clean the spray gun
Pick up pipe clogged Clean Paint Feed Tube
Air hose split Replace air hose
Gritty paint Filter the paint
Container almost Refill container
empty
Spray gun at an angle Ensure Paint Feed Tube
tniap sdrawot delgna si
Air intake Check the condition of
blocked the Filter and clean as neccessary
Unit will not Circuit breaker tripped Check the back of the unit. If the circuit
start (HV7000 unit) breaker has tripped, a white push button
.teser ot ni hsuP .raeppa lliw rotacidni
esaelp ,melborp eht eruc ton seod siht fI
.tnega ecivres tseraen ruoy ot refer
House circuit breaker Check and reset if required.
PROBLEM CAUSE ACTION REQUIRED
TROUBLESHOOTING
11