Filter
Top Products
4
Water based paints and 45 - 60 seconds
emulsions
Oil based paints 45 - 50 seconds
Wood preservatives No dilution
Primers 45 - 50 seconds
Varnishes Manufacturers ratio
Aluminium paints Manufacturers ratio
Wood stains Manufacturers ratio
Cellulose Manufacturers ratio
IDEAL VISCOSITY
This spray applicator can be used with products having a viscosity ranging from 10 to a
maximum of 60
seconds.
Dip the viscosity cup into the material and fill up. Time how long
it takes for the viscosity cup to empty (Fig.3).
Using the above chart (or manufacturer’s instructions) as a guide determine if the material
requires further thinning, if so then thin accordingly.
Fig.3
OPERATION
PREPARATION
● Fill the paint container with the material to be sprayed. DO NOT OVERFILL above MAX level indicator. Push
the Feed Tube firmly into the base of the spray applicator body and re-fit the paint container into the spray
applicator body. (See exploded view on page 8 to show the fitting detail for the different spray applicator
types.)
● Unwind the hose from the Carrier Stand & screw the motor end of the hose to the outlet port at the front of
the turbine unit. Connect the spray applicator end of the hose to the spray applicator using the quick release
connector. Uncoil the power cord and plug it in to a suitable power outlet.
ALWAYS KEEP THE MOTOR UNIT AS FAR AWAY FROM THE SPRAYING AREA AS POSSIBLE TO
PREVENT PAINT CONTAMINATING THE MOTOR.
TAPE ANY AREA YOU DO NOT WISH TO SPRAY.
Once you have set up ready to spray, switch on the unit. No paint will be sprayed until the trigger on the spray
applicator is gently pulled. Before starting any work on spraying actual objects we suggest you spend some
time practicing on cardboard or newspaper until you have got used to how the spray applicator works.
SETTING UP YOUR SPRAY APPLICATOR
● Choose the best Needle & Fluid Tip for your application.
Your Spray Port is supplied to you with a 0.08” diameter Needle & Fluid Tip. This is a good size for most
applications. However, there are other sets available to cater for a wider range of materials that you may want
to spray. In general, the larger the diameter of the Needle & Fluid Tip, the more suitable it is for higher viscosity
materials. The larger diameters also allow a greater volume of material to be applied. The smaller diameters
are more suitable for low viscosity materials & lighter application. For the Spray Port type “P”, Needle & Fluid
Tip sets are available at 0.04” and 0.06” diameter. For the Spray Port type “A”, Needle & Fluid Tip sets are
available at 0.04”, 0.06” and 0.10” diameter. See page 8 for details.
NEEDLE SELECTION GUIDELINES
Needle/Fluid Tip Size Material
0.04/0.06” Cellulose, Acrylics, Synthetics, Polyurethane, Lacquers,
Fluorescents, Wood Stains
0.06/0.08” Oil base, Hammers, Oxides, Primers, Air Drying, Enamels, Varnish,
Marine Paint, Multi-Colour, Industrial Synthetics, Latex Oils,
Polyurethane, Aluminium
0.08/0.10” Emulsions, Chlorinated rubber, Oxides, Zinc Rich Primers, Epoxy
Plastic Adhesives, Polyurethane, Floor Paving Paints
N0150 05/05.qxd 27/5/05 10:28 am Page 4