Filter
Top Products
6
SPRAY APPLICATOR
1. Remove the gun container.
2. Pour any leftover paint into its container so that it
can be used for the future.
3. Pour a quantity of the respective thinner into
container, shake the spray applicator lightly,
reassemble the gun, then spray this liquid
through the gun. Repeat this until the thinner
being sprayed is coming through with
no traces of paint.
4. Clean any traces of paint off the outside of the
spray applicator.
5. Clean the container Seal inside the spray
applicator body for Type P or inside the spray
applicator body for Type A.
CLEANING INSTRUCTIONS
Remember to disconnect the unit from the mains power when undertaking any cleaning of the Spray Port.
THE SPRAY APPLICATOR MUST BE THOROUGHLY CLEANED IMMEDIATELY AFTER USE. IF THE
PAINT DRIES INSIDE THE GUN, CLEANING WILL BECOME MUCH MORE DIFFICULT AND MAY RENDER
THE GUN INOPERABLE. THIS IS NOT COVERED BY WARRANTY.
The spray applicator is the same as a paintbrush, if it is not cleaned it will go hard and can become useless.
You must therefore clean this out after use.
FLUID TIP & NEEDLE (Type P)
1. Unscrew Air Cap Ring (1)
2. Remove the Air Cap (2)
3. Completely remove Fluid Adjusting Screw (8)
4. Remove the Spring (7)
5. Remove the Fluid Tip Needle (6) by gently pulling
the trigger
6. Remove Direction Plate noting the position of
notches (3)
7. Remove the Fluid Tip (4)
8. Remove Fluid Tip Seal (5)
9. Remove Paint Container Seal (12)
10. Place all of these items into a container and clean
them using a brush and clean thinners
11. Clean the inside of the body of the gun
12. Thoroughly dry these parts before reassembling
13. Grease the Gland (10)
14. Reassemble parts in reverse order
It is recommended fitting the Fluid Tip (4) prior to the needle
FLUID TIP & NEEDLE (Type A)
1. Remove the Air Cap Ring (1)
2. Remove the Air Cap (2)
3. Remove Direction Plate & Spring Assembly (3)
4. Unscrew Adjusting Screw (12) & pull out the
Needle (9) & Needle Spring (11).
5. Use the spanner supplied to remove the Fluid Tip
(4) & Fluid Tip Seal (5)
6. Immerse all of the parts above in thinners & clean
them thoroughly using the cleaning kit supplied
with the gun.
7. Before refitting the Needle, dip its end into some
vasaline. This will automatically lubricate the
gland washer as it is inserted.
8. The external surfaces of the spray applicator can
be wiped clean with a cloth soaked in thinners.
NEVER DISPOSE OF PAINTS OR SOLVENTS INTO DRAINS. CONTACT YOUR LOCAL COUNCIL TO
ARRANGE COLLECTION OR FOR DETAILS OF NEAREST REGISTERED DISPOSAL SITE.
TURBINE UNIT AND CARRIER STAND
● The Turbine unit and the Carrier and Stand can be cleaned using a damp cloth and a little thinners to
remove paint stains.
N0150 05/05.qxd 27/5/05 10:28 am Page 6