Filter
Top Products
12
1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Starter.
2. REAR HANDLE ASSEMBLY - Sturdy handle for right hand placement. Includes stop switch and throttle trigger.
3. THROTTLE TRIGGER LOCKOUT - This lever must be depressed before throttle trigger can be operated.
4. STOP SWITCH - Mounted on top of handle assembly. Move switch forward to run, back to stop.
5. THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration press trigger gradually for
best operating technique.
6. SHOULDER HARNESS - An adjustable strap that suspends the unit from the operator.
7. LOWER SHAFT TUBE - Durable fiberglass mesh housing.
8. MUFFLER, SPARK ARRESTER - The muffler controls the exhaust noise while the spark arrestor prevents hot, glowing
particles of carbon from leaving the muffler where they could possibly start a fire.
9. RECOIL STARTER - Pull recoil handle slowly until starter engages, then quickly and firmly. When engine starts return
handle slowly. DO NOT let handle snap back or damage will occur.
10. FUEL TANK - Contains fuel and fuel filter.
11. FUEL TANK CAP - Covers and seals fuel tank opening.
12. PRIMER BULB - Pumping primer bulb before starting engine draws fresh fuel from the fuel tank priming the carburetor
for starting. Pump the bulb 10 times until fuel is visible in clear fuel return line.
13. AIR CLEANER ASSEMBLY - Contains replaceable air filter element.
14. CHOKE - Located above air cleaner housing. Controls operation of choke. Move lever to start position (Close Choke)
and back to run position (Open Choke).
15. SPARK PLUG - Provides spark to ignite fuel mixture.
16. ARM REST - Provides arm rest during operation and protects arm from hot engine.
17. AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.
18. SAW CHAIN - 90 SG 9.53 mm (3/8 in.) low profile Oregon saw chain. Runs approximately 609.6 m/min. (2000 ft/min) at
full throttle.
19. GUIDE BAR - 254 mm (10 in.) guide bar (PPT-2100), 305 mm (12 in.) guide bar (PPT-2400).
20. CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, accelerate
and lower saw chain into branch.
21. CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.
22. OPERATORS MANUAL - Read and understand this manual before operation. Keep manual in a safe location for future
reference, i.e., operation, maintenance, storage and specifications.