Filter
Top Products
CMY ZOOM 250™
©Elation Professional® Los Angeles, Ca. 90058 - CMY ZOOM 250™ - -
Error Messages
When you turn on the fixture, it will make a reset first. The display may show “XXer”
while there are problems with one or more channels. “XX” stands for the channel
equipped with a testing sensor for positioning.
For example,
when the display shows “03Er”, it means there is some error in channel 3. If
there are some errors on channel 1, channel 2, channel 3 at the same time, you may see the
error message “01Er”, “02Er”,”03Er” flash repeatly for 5 times, and then the fixture will
generate a reset signal, all the stepper motors will reset. If the error messages maintain after
performing reset more than 3 times, it will detect whether the fixture has more than 3 errors.
If the fixture has more than 3 errors (including 3 errors), all the channels can not work
properly; but if the fixture has less than 3 errors, only the channels which have errors can not
work properly, others can work as usual.
01Er:
(Color-wheel error) This message will appear after the reset of the fixture if the
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the
stepping-motor is defective (or its drive circuit on the main PCB). The color wheel is not
located in the default position after the reset.
07Er:
(Effect-wheel error) This message will appear after the reset of the fixture and if the
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the
stepping-motor is defective (or its driver circuit on the main PCB). The effect-wheel is not
located in the default position after the reset.
08Er:
(Zoom-error) This message will appear after the reset of the fixture and if the
magnetic-indexing circuit malfunctions (sensor failed or magnet missing) or the
stepping-motor is defective (or its driver circuit on the main PCB). The zoom is not located in
the default position after the reset.