Filter
Top Products
Design Par 575H™
©Elation Professional® 12 Design Par 575H™
protect the electronics in the event of severer power fluctuations. Never defeat this
fuse. In the event of fuse failure, always be sure to replace with an exact match fuse
unless other wise specified by an authorized Elation Professional technician.
13) DMX OUT JACK – This 3-pin XLR jack sends a DMX signal to another DMX fixture.
For best results this jack should be terminated if it is the last fixture in a DMX daisy
chain (see DMX termination on page 21).
14) DMX IN JACK – This 3-pin XLR jack is receives an incoming DMX signal from a
DMX controller.
15) OMEGA CLAMP SOCKET – This fixture uses a cam-lock clamp system that allows
a quick and efficient means to secure a clamp to the unit. To attach a clamp to the
unit, attach a clamp that is rated to handle the weight of the unit to your omega
clamp. After a clamp has been attached to the omega clamp, attach the cam locks
to the designated position on the bottom of your unit. Lock the cam locks into
position by turning the wing nuts 90°. See page 18 for proper clamp mounting and
assembly.
16) SAFETY CABLE RIGGING POINT – The fixture provides a built-in rigging point for
a safety cable on the underside of the fixture, be sure to use this point and never
secure a safety cable to a carrying handle.
17) BASE COOLING FAN – This fan is used to cool the internal temperature of the
base electronics.