Filter
Top Products
Design Spot 250™
©Elation Professional® 23 Design Spot 250™
CEDT
ON/OFF
Edit program via controller
REC.
RE.XX
Auto Save
RUN
ON/OFF
Program test
Main Menu Functions
1. ADDRESS MENU
- AOO1 - A511 (Value) - This is where you set the fixtures DMX address.
Setting/Changing the DMX Address
After applying power to the DESIGN SPOT 250™ the LED will display the fixture’s
current DMX address immediately after the reset sequence. If the fixture is not
receiving a DMX signal the display will flash continuously. To set or adjust a DMX
address, please follow the procedure below:
1. Switch on the DESIGN SPOT 250™ and wait for the fixture reset process to
finished.
2. Press the Mode/Esc button to access the main menu. Toggle through the menu by
pressing the Up and Down buttons until the display shows A001. Tap the enter
button to make changes to the address, the current three digit address will
immediately begin to flash.
3. While the current three-digit address is flashing, use the Up and Down buttons to
select adjust the address. Lock your new address into the unit’s memory by
pressing the Enter button. After the new address has been successfully stored into
the fixture’s memory the LED will briefly readout PASS.
The DMX address is non-destructible and will remain in the fixture’s memory even when
power to the fixture has been switched off. Memory is backed-up and retained by an
internal power source with a five year shelf life.
2. TEST MENU
- T-01 - T -XX (Test) - T ests the functions of each channel. There are 16 DMX
channels, and all except channels 7, 11, and 15 can be tested. To enter the test menu
follow the procedure below:
1. Access the main menu.