Filter
Top Products
2.6
PK 255
Rip fence
The rip fence slides onto the saw from the right-
hand side and locks on the saw’s front.
The auxiliary fence extrusion can be repositioned
after loosening the two wing nuts:
· small edge (as shown):
- for cutting thin stock;
- when the saw blade is tilted.
· wide edge:
- for cutting thick stock
(max. 65 mm).
Mitre fence
The mitre fence can be fitted into groove of either
the sliding carriage or the saw table. It is locked in
the groove with the ratchet lock lever (black arrow).
For mitre cuts the fence extrusion turns through 45˚
in both directions. To set a mitre angle loosen lock
lever (grey arrow).
Assembly and connection
Installation of legs
1. Put a rubber foot on each of the four legs (on the
side with the skewed corner).
2. Turn saw over and place on the saw table.
3. Insert legs into recesses at the corners of the
machine housing.
4. Fasten legs with 4 each
- hexagon head screw M 8x16;
- serrated lock washer;
- washer;
- hexagon nut M 8.
5. Stand saw on its feet
6. Retighten fastening screws on all four legs.
Connect to dust collector
A
Danger!
Some kinds of wooden dust (e.g. from oak
and ash) can be carcinogenic when inhaled.
When working indoors always connect to a suit-
able dust collector (air speed at suction port of
saw ³ 20 m/s).
A
Caution! Operation without a dust collector is
only possible
- outdoors;
- for a short duration (up to max.
30 minutes);
- with a dust mask.
If no dust collector is connected saw dust and
chips build up inside the chip case. These
need to be removed after latest 30 minutes of
operation.
Dust collection ports are provided on the saw blade
guard and the chip case.
25
20
15
10
5
0
30
35
30
45
15
0
15
30
45