Filter
Top Products
23
ENGLISH
2. Loosen screws (61).
3. Adjust position of guide bearing sup-
port (62) so that the guide bearings
(63) are positioned approx. 1 mm
behind the tooth gullet.
4. Tighten screws (61) again.
5. Loosen screws (64).
6. Press guide bearings (65) together
(against the band saw blade).
7. Turn the band saw wheel by hand in
a clockwise direction several times
to bring the guide bearings in correct
position – both guide bearings
should just touch the band saw
blade.
8. Tighten screws (64) again.
9. Adjust thrust bearing position (67)
so it just touches the band saw
blade.
10. Tighten the ratchet lock lever (66)
again.
9.4 Lower blade guide align-
ment
The lower blade guide consists of:
− a thrust bearing (supports the band
saw blade from the rear),
− two guide pins (providing lateral
support).
These need to be readjusted after every
band saw blade change and/or tracking.
1. Loosen the four thumb screws (68)
and remove the fence guide extru-
sion (69).
2. Remove the saw table (70) from the
upper table trunnion (71).
3. Raise upper blade guide fully.
4. Loosen screw (72) so the thrust
bearing will slide back and forth eas-
ily.
5. Loosen screw (73).
6. Adjust position of supports (74) so
that the pilot pins (75) are positioned
approx. 1 mm behind the tooth gul-
let.
7. Tighten screw (73) again.
8. Loosen screws (76) with a hex.
wrench.
9. Press guide pins (77) together
(against the band saw blade).
10. Turn the band saw wheel by hand in
a clockwise direction several times
to bring the guide pins in correct
position – both guide pins should
just touch the band saw blade.
11. Tighten screws (76) again.
59
60
1mm
61
62
63
64
65
66
67
68
69
70
71
72
1mm
73
74
75
76
77