Filter
Top Products
2.9
PK 255
Rip cuts with rip fence
1. Lock rip fence in required position on saw table.
A
Danger!
Use push stick if distance between rip fence
and saw blade is less than 120 mm.
2. Reposition auxiliary fence extrusion if neces-
sary:
- Low edge (as shown) =
for sawing thin stock;
and with a tilted saw blade.
- High edge =
for cutting thick stock
(max. 65 mm)
3. Set depth of cut.The blade guard should be set
to approx. 10 mm above the workpiece.
4. Set blade tilt and lock in position.
5. Start motor.
6. Cut workpiece in a single pass.
7. Switch machine off if no further cutting is to be
immediately afterwards.
Care and maintenance
A
Danger!
Prior to all servicing:
- Switch machine OFF.
- Unplug power cable.
- Wait until the saw has come to a complete
stop.
· Check that all safety devices are operational
again after each service.
· Replace defective parts, especially of safety
devices, only with genuine replacement parts.
Parts not tested and approved by the equipment
maker can cause unforeseen damage.
· Repair and maintenance work other than
described in this section shall only be carried out
by qualified specialists.
Saw blade change
A
Danger!
Risk of injury by the saw blade’s teeth. Wear
gloves when changing blades.
1. Remove the two fastening screws of the remov-
able table section.
2. Lift removable table section up and remove.
3. Raise blade fully.
4. Take blade guard off.
5. Lift chip case cover slightly and swing to the
side. The cover is hooked into the bottom of the
chip case and can not fall down.
25
20
15
10
5
0
30
35