Filter
Top Products
2.5
PK 255
Operating controls
On/off switch with emergency stop
· To switch ON = press green button.
· To switch OFF = press red button or cover of on/
off switch.
3
An undervoltage relay trips in the event of a
voltage failure, to prevent a restarting of the
saw when the power is restored. To start the
saw again after a power failure press the
green button.
To prevent unauthorized use the switch can be
blocked with a padlock.
Handwheel for blade tilt setting
The saw blade can be tilted steplessly between 0°
and 45°.
The centre of motion is at saw table level, so the
depth of cut remains the same, regardless of the
bevel angle.
Ratchet lock lever
The set bevel angle can be locked with a ratchet
lock lever, so it does not change during sawing.
3
There are several ratchet lock levers on the
saw. If the swivelling range is not sufficient,
the lever position can be shifted:
pull lever up, turn and let engage again.
Handwheel for setting the depth of cut
The depth of cut can be adjusted by turning the
handwheel.
3
To compensate for possible play in the blade
height setting mechanism, always raise the
blade to the desired position.
25
20
30
35
25
20
30
35
25
20
15
10
5
0
30
35
25
20
15
10
5
0
30
35