Filter
Top Products
3
c) Disconnect the plug from the power
source before making any adjustments,
changing accessories, or storing power
tools. Such preventive safety measures re-
duce the risk of starting the power tool ac-
cidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for mis-
alignment or binding of moving parts,
breakage of parts and any other condi-
tion that may affect the power tools op-
eration. If damaged, have the power tool
repaired before use. Many accidents are
caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc., in accordance with these
instructions and in the manner intended
for the particular type of power tool, tak-
ing into account the working conditions
and the work to be performed. Use of
the power tool for operations different from
those intended could result in a hazardous
situation.
5) Service
a) Have your power tool serviced by a
qualifi ed repair person using only identi-
cal replacement parts. This will ensure that
the safety of the power tool is maintained.
TO REDUCE THE RISK OF
INJURY, USER MUST READ AND UNDER-
STAND INSTRUCTION MANUAL.
Various dust created by power
sanding, sawing, grinding, drilling and other
construction activities contains chemicals
known (to the State of California) to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals
are:
Lead from lead-based paints,
Crystalline silica from bricks and cement
and other masonry products,
•
•
Arsenic and chromium from chemically-
treated lumber.
The risk from these exposures varies, depend-
ing on how often you do this type of work.
To reduce your exposure to these
chemicals work in a well ventilated
area and use approved safety equip-
ment, such as dust masks that are
specially designed to fi lter out micro-
scopic particles.
Technical data
Wattage 200 W
No load speed 5000 - 14000 rpm
No. of strokes 10000 - 28000 spm
Sanding stroke 2.0 mm (0.079 in.)
Sanding base (delta form)
80 x 150 mm (3.1 x 5.9 in.)
Weight 1.3 kg (2.9 lbs.)
Safety llevel
/ II
Symbols
V volts
A amperes
Hz hertz
W watt
~ alternating current
n
0
no load speed
Class II Construction
rpm revolutions per minute
spm strokes per minute
Intended use
The sanders are designed for sanding wood,
plastic, composite materials, paint / varnish,
fi lling material and similar materials. Metal
and materials with an asbestos content must
not be processed with these tools.
The machine is particularly suitable for pro-
cessing smaller surfaces and overhead work
because of its size, its weight and its out-
put.
The machines must not be damp nor operated
in a damp environment for electrical safety
reasons. The machines may only be used for
dry sanding.
•