Filter
Top Products
14
Open the lever [17.4].
Remove the base runner [17.1].
Release the lever [17.4] again.
Insert a copying ring [17.3] in the correct
position on the router base.
Insert the tabs [17.2] on a base runner into
the router base.
Push down the base runner until it engages
in the router base.
The overhang Y of the workpiece in relation
the template is calculated as follows:
Y
Y = ½ (diameter of copying ring minus
diameter of routing bit)
c) Edge trimming
Routing tools with a bearing guide are required
when the machine is used for edge trimming.
The machine is then guided in such a way that
the bearing guide rolls off the workpiece.
When trimming edges, always use the chip
defl ector KSF-OF to improve dust extrac-
tion.
d) Routing with a guide system FS
The guide system (partly as an accessory)
makes it easier to route straight grooves.
19.10
19.9
19.8
19.7
19.5
19.6
19.4
19.1
19.2
19.3
X
Secure the guide rail to the workpiece using
clamps [19.4].
Insert the base runner [19.3] for the guide
stop into the router base (see "Changing
the base runner").
–
–
–
–
–
–
–
–
This base runner is offset to compensate
for the height of the guide rail.
Secure both guide rods [19.6] with the
rotary knobs [19.5] and [19.9] on the
guide stop.
Unscrew the rotary knob [19.1].
Insert the guide rods [19.6] into the
grooves on the router base.
Place the router with the guide stop on the
guide rail.
If required, you can adjust the play of the
guide stop on the guide rail by adjusting
the two guidance jaws [19.2] with a
screwdriver.
Slide the router along the guide rods until
the routing tool reaches the required
distance X from the guide rail.
Screw up the rotary knob [19.1].
Unscrew the rotary knob [19.10].
Turn the adjusting wheel [19.7] to adjust
distance X more precisely.
Hold the adjusting wheel [19.7] to turn the
scale [19.8] independently to "zero".
Screw up the rotary knob [19.10].
Changing the base runner
Festool offers special base runners (as an
accessory) for different applications.
Change the base runner as follows:
20.1
20.2
20.3
Lay the machine on its side on a stable
base.
Open the lever [20.3].
Remove the base runner [20.1].
Release the lever [20.3] again.
Insert the tabs [20.2] on a base runner into
the router base.
Push down the base runner until it engages
in the router base.
f
–
–
–
–
–
–
–
–
–
f
–
–
–
–
–
–
–