Filter
Top Products
12
b) Edge trimming with bearing guide
10-1
Use routing tools with a bearing guide in the
machine when edge trimming with the large
surface router table. The machine is then
guided in such a way that the bearing guide
rolls off the workpiece.
When trimming edges, always use the under-
table extractor adapter [10-1] for improved
dust extraction.
c) Edge trimming with sensor and router
table for edge veneer
11-1
1,5°
When edge trimming with the router table for
edge veneer (only in SET scope of delivery), fi t
the sensor [11-1] to the machine (see “Router
table for edge veneer “). The machine is then
guided in such a way that the sensor rests
against the workpiece.
Aluminium processing
Risk of accident - always
perform the following safety measures
when routing aluminium:
Add a residual-current circuit-breaker f
(FI, PRCD).
Connect the machine to a suitable dust f
extractor.
Remove dust deposits from the motor hous- f
ing on a regular basis.
Wear protective goggles. f
Service and maintenance
Any maintenance or repair
work that requires opening of the motor
or gear housing should only be carried
out by an authorised Customer Service
Centre (name supplied by your dealer)!
Maintenance or repair work carried out by an
unauthorised person can lead to the wrong
connection of the power leads or other com-
ponents, which in turn can lead to accidents
with serious consequences.
To prevent accidents, always
remove the plug from the power supply
socket before carrying out any mainte-
nance or repair work on the machine! Do
not use compressed air to clean the electri-
cal tool! Do not try to clean parts inside the
machine in this way, as you could let foreign
objects in through the openings of the ma-
chine housing.
Certain cleaning agents and
solvents are harmful to plastic parts.
Some of these are: gasoline, carbonyl chlo-
ride, cleaning solutions containing chlorine,
ammonia and household cleaners containing
ammonia.
To assure the circulation of air, the cool air f
vents in the motor housing must always be
kept clear and clean.
This unit is fi tted with special, automati- f
cally disconnecting carbon brushes. If these
become worn, the current is automatically
switched off and the unit shuts down. In
this case, take the unit to an authorised
Customer Service Centre and have the
carbon brushes changed.
Accessories, tools
For safety reasons, only use
original Festool accessories and tools!
The accessory and tool order number can be
found in the Festool catalogue or on the In-
ternet under www.festool-usa.com.
Systainer
Many Festool products are shipped in a unique
system container, called "Systainer". This pro-
vides protection and storage for the tool and
accessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.