Filter
Top Products
6
min
-1
Revolutions per minute
Ø Diameter
Tip, advice L
Safety instructions
General safety instructions
Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fi re and/
or serious injury.
Save all warnings and instructions for future
reference.
The term “power tool” in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
1 WORK AREA SAFETY
a) Keep work area clean and well lit. Cluttered
and dark areas invite accidents.
b) Do not operate power tools in explosive atmo-
spheres, such as in the presence of fl ammable
liquids, gases or dust. Power tools create
sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while op-
erating a power tool. Distractions can cause you
to lose control.
2 ELECTRICAL SAFETY
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodifi ed plugs and matching outlets
will reduce risk of electric shock.
b) Avoid body contact with earthed or grounded
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of elec-
tric shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet condi-
tions. Water entering a power tool will increase
the risk of electric shock.
d) Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords in-
crease the risk of electric shock.
e) When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of
a cord suitable for outdoor use reduces the risk
of electric shock.
Symbols
Warning of general danger
Risk of electric shock
Wear a dust mask!
Wear ear protection.
Clean the air vent slits and dust fi lter
Read the Operating Instructions/Notes!
V Volts
A Amperes
Hz Hertz
W Watt
~ Alternating current
n
0
No load speed
Class II Construction
rpm
Content
Symbols .............................................................6
Safety instructions ............................................6
Technical data ...................................................9
Functional description ......................................9
Intended use ....................................................10
Commissioning ................................................10
Extension cord ................................................ 10
Machine settings .............................................10
Fitting the
PLANEX ........................................... 10
Electronics ....................................................... 11
Changing sanding pads ................................... 11
Affi xing abrasives ............................................ 12
Adjusting the internal/external extraction ..... 12
Adjusting the suction power ............................ 12
Sanding close to edges .................................... 13
Dust extraction ................................................ 13
Operation .........................................................13
Service and maintenance ................................ 15
Accessories, tools ...........................................15
Disposal ........................................................... 16
Warranty .........................................................16
Troubleshooting .............................................. 16