Filter
Top Products
Fault Finding Hints
Cutting blade stops under load
1. Cut at a slower pace.
2. If cutting blade still stops under load?
Disconnect from the Power Pack and con-
sult your local approved Service Centre.
Fails to stop when one switch lever is released.
Immediately disconnect from the Power
Pack and consult your local approved
Service Centre.
Poor cut quality
1. Ensure the product is being used correctly
(see How to Use)
2. Ensure blades are free from trapped debris
3. Damaged Blades?
Immediately disconnect from the Power
Pack and consult your local approved
Service Centre.
Excessive Vibration
Immediately disconnect from the Power
Pack and consult your local approved
Service Centre.
Husqvarna Outdoor Products are manufactured
under an Environmental Management System (ISO
14001) using, where practical, components manu-
factured in the most environmentally responsible
manner, according to company procedures, and
with the potential for recycling at the end of the
products’ life.
• Packaging is recyclable and plastic compo-
nents have been labelled (where practical) for
categorised recycling.
• Awareness of the environment must be considered
when disposing of ‘end-of-life’ product.
• If necessary, contact your local authority for
disposal information.
The symbol on the product or on its packag-
ing indicates that this product may not be treated
as household waste. Instead it shall be handed
over to the applicable collection point for the
recycling of electrical and electronic equipment.
By ensuring this product is disposed of correctly,
you will help prevent potential negative conse-
quences for the environment and human health,
which could otherwise be caused by inappropri-
ate waste handling of this product.
For more detailed information about recycling of
this product, please contact your local council
office, your household waste disposal service or
the shop where you purchased the product.
If any part is found to be defective due to faulty
manufacture within the guarantee period,
Husqvarna Outdoor Products, through its Authorised
Service Repairers will effect the repair or replace-
ment to the customer free of charge providing:
(a) The fault is reported directly to the Authorised Repairer.
(b) Proof of purchase is provided.
(c) The fault is not caused by misuse, neglect or
faulty adjustment by the user.
(d) The failure has not occurred through fair wear and tear.
(e) The machine has not been serviced or repaired,
taken apart or tampered with by any person not
authorised by Husqvarna Outdoor Products.
(f) The machine has not been used for hire.
(g) The machine is owned by the original purchaser.
(h) The machine has not been used outside of the
country for which it was specified.
(i) The machine has not been used commercially.
* This guarantee is additional to, and in no way
diminishes the customers statutory rights.
Failures due to the following are not covered, there-
fore it is important that you read the instructions con-
tained in this Operator's Manual and understand how
to operate and maintain your machine:
Failures not covered by guarantee
* Replacing worn or damaged blades
* Failures as a result of not reporting an initial fault.
* Failures as a result of sudden impact.
* Failures as a result of not using the product in
accordance with the instructions and recommen-
dations contained in this Operator's Manual.
* Machines used for hire are not covered by this guar-
antee.
* The following items listed are considered as
wearing parts and their life is dependent on regu-
lar maintenance and are, therefore not normally
subject to a valid warranty claim: Blades
* Caution!
Husqvarna Outdoor Products does not accept lia-
bility under the warranty for defects caused in
whole or part, directly or indirectly by the fitting of
replacement parts or additional parts that are not
either manufactured or approved by Husqvarna
Outdoor Products, or by the machine having
been modified in any way
Guarantee & Guarantee Policy
Environmental Information