Filter
Top Products
48
9 Click [Finish].
10 Click [Close].
` Click [Advanced] tab, and change the value in [Adaptive Inter Frame Spacing] to
[On] if it is [Off].
11 Restart the system.
For LAN card names displayed in the [Device Manager] after the driver installation, refer to "2.4
Displayed LAN Card Names" (
Jpg.49).
Referring to "1.2 Module Version Level" (
Jpg.45), check that the drivers updated for all LAN
adapters are correctly updated and that the version is correct.
2.2 Adding a Card
When the system is started right after OS installation or new LAN card installation, the [Found NEW
Hardware] window may appear. The driver will be automatically installed.
However, when other driver than this driver is installed, refer to "2.1 Updating the Driver" (
Jpg.47)
to install a driver. For checking the version level, refer to "1.2 Module Version Level" (
Jpg.45).
When [Start new hardware search wizard] appears, click [Cancel] to close the window, and refer to
"2.1 Updating the Driver" (
Jpg.47) to install a driver.
` [This device cannot start. (Code 10)] may be displayed, but this is not a
problem since the system will operate normally after reboot. After pressing
[Finish], [Help and support center] appears. Click the [x] on the upper right
in the window.
` Do not set a small value in the [Receive Descriptors] in the LAN adapter properties.