Genesis Advanced Technologies GCS100 Cordless Saw User Manual


  Open as PDF
of 11
 
English
7 1⁄4” Circular Saw
Operator’s Manual GCS100
OPERATION
WARNING:
7-1/4” is the maximum blade capacity of your saw. Never use a blade that is too thick to allow the outer flange washer
to fit properly on the spindle. Too thick a blade will prevent the blade bolt from securing the blade on the spindle.
Larger diameter blades will contact the blade guards. Either situation could result in a serious accident.
Blade Installation
 
 
 
 
 
 
 
 
 
 
Removing the Blade
 
 
 
 
 
 
 
 
CAUTION:
Always be sure that the tool is unplugged from the power source before making any adjustments or attaching accessories.
Adjusting the Depth of Cut
 
 
 
OR
 


 
Note: Always maintain the correct blade depth setting. For all cuts the blade depth should not exceed 1⁄4” below the
material being cut. Excessive blade depth increases the chance of saw KICKBACK.
Bevel Angle Adjustment
 
 
 
 

 previous next