Filter
Top Products
10
spindle lock engages and locks the spindle. Use the pin
wrench (11) to unscrew the outer flange (13). Note that
this flange unscrews anticlockwise. (Fig. I)
2. Remove the outer flange (13) (Fig. J) and the used
disc.(Fig. K)
3. Clean the flanges (13 and 15) and check the new disc.
4. Ensure that the non-threaded
inner flange (15) is on the
spindle and located correctly.
The two machined flat
sections on the inner flange
(15) must face the angle
grinder and locate in the
matching positions on the
spindle. (Fig. L)
Fit the new disc, ensuring that
the disc is correctly located on the inner flange.
NOTE. Make sure that you select the correct disc for the
planned application, i.e. fit a metal grinding disc for cutting
metal, a masonry grinding disc for grinding masonry, a
cutting disc for cutting, etc.
5. Fit the outer flange (13) with the raised centre section
facing outwards as
shown in the picture below.
(Figs. M and N)
IMPORTANT. The depressed centre disc must be correctly
located on the inner flange. Refer to the assembly drawing
below.
6. Turn the new disc by hand, ensuring that it is tight in
the flanges and that it rotates fully and does not wobble
unduly.
7. Run the angle grinder no load for at least one minute
to ensure the new disc is in good condition. Make sure
you are wearing all the safety gear and that you face the
grinder away from you.
Flat Disc
1. To remove the disc, press and hold the spindle lock
button (2) and rotate the disc by hand until the spindle
lock engages and locks the spindle. Use the pin wrench
(11) to unscrew the outer flange (13). Note that this flange
unscrews anticlockwise.
2. Remove the outer flange (13) and the used disc.
3. Clean the flanges (13 and 15) and check the new disc.
4. Ensure that the non-threaded inner flange (15) is on
the spindle and located correctly. The two machined
flat sections on the inner flange (15) must face the
angle grinder and locate in the matching positions on
the spindle. Fit the new disc, ensuring that the disc is
correctly located on the inner flange.
NOTE. Make sure that you select the correct disc for the
planned application, i.e. fit a metal grinding disc for cutting
metal, a masonry grinding disc for grinding masonry, a
cutting disc for cutting, etc.
J K
L
N
M