Filter
Top Products
13
Sanding small end surfaces
on the sanding disc
1. Use of the mitre gauge
is recommended for this
operation.
2. Rest the workpiece against the
edge of the mitre gauge.
3. Always move the work across
the left hand side of the
sanding disc.
4. The table may be tilted for bevelled work.
Maintenance
Note: Always wear eye protection when cleaning the tool.
WARNING: Always ensure that the saw is switched off and
unplugged from the power supply before carrying out any
maintenance or cleaning.
1. Keep the tool’s air vents unclogged and clean at all times.
2. Remove dust and dirt regularly. Cleaning is best done
with a brush or a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
CAUTION: Do not use cleaning agents to clean the
plastic parts of the tool. A mild detergent on a damp cloth
is recommended. Water must never come into contact with
the tool.
Power cord maintenance
If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer’s agent, or an
authorised service centre in order to avoid a safety hazard.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Repairs
Only an authorised service centre should replace the
cordset or carry out other repairs.
Once a month, lubricate all moving parts with machine
oil. Take care to keep the oil away from any electrical
components.
Parts should only be replaced or repaired by an authorised
service centre.