Filter
Top Products
11
Battery charging
This battery is recommended for the use of a residual
current of 30mA or less.
•
The battery supplied with this tool is model number 1G18LiB.
• The Charger Pack supplied with this tool is model
number 1835C.
• The Charger Adaptor supplied with this tool is model
number 1835LiA.
Note. Only use the supplied batteries, charger and adaptor.
IMPORTANT. Before plugging in the power supply from the
charger to the slim line adaptor always ensure that the plug
is switched off at the mains.
IMPORTANT. The battery will be fully charged after
approximately 3-5 hours, remove it from the adaptor after
this time.
Do not leave a battery charging for longer than 24 hours.
1. Align and slide the slim line
adaptor (10) onto the battery
until the battery pack latches
“click” into position. Check
the adaptor is flush with the
battery and there is a firm
connection.
2. Connect the power supply
from the charger (9) to the slim
line adaptor via the socket in
the rear of the adaptor housing.
3. Plug in the charger and switch
on. The red LED indicator will
show power to the adaptor
and
that charging is taking place.
4. The battery charging time is
approximately 3 - 5 hours to
charge a low charged battery, but will be shorter if the
battery is already partially charged. The red LED goes
out when the charging cycle is complete. Turn off the
charger power supply from the mains and then remove
the battery from the adaptor.
WARNING. Only use charger 1835C with the adaptor
(1835LiA) that is supplied for the 1G18LiB battery pack.
To obtain the best life for the battery
For battery storage and when the drill is not being used, it is
advised to charge the battery to approximately half charge.
Leaving the battery in the fully charged condition can
shorten the cell life.
Short charging is acceptable with these cells.
Prevent constant overloading of the drill.
Avoid allowing lose items like screws or nails etc. to be
stored with battery packs as these or similar items can
short battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in
a dry secure place.
Avoid charging, using or storing your battery in
temperatures below 0ºC and above 40ºC.
Using the drill
Use the forward/reverse switch
(4) to select the direction of
rotation, then pull the trigger
(3). This trigger switch is an
electronic variable speed control
which enables the user to vary
the speed continuously. The
speed varies according to how far
the trigger switch is depressed,
the further it is depressed the
faster the chuck will rotate and the
lighter it is depressed, the slower
it will rotate.
To stop the drill, release the
trigger switch.
Note. You can only change the
direction of rotation of the drill
using the forward/reverse switch
when the trigger is NOT depressed.