Filter
Top Products
cookers and refrigerator enclosures.
20. Use only approved parts. When servicing, use only
identical replacement parts. Use an authorised service
facility to fit replacement parts.
Additional safety rules for sanders
Warnings. Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on
the nameplate of the tool. A power source with a voltage
greater than that specified for the tool can result in
serious injury to the user, as well as damage to the tool.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful
to the motor.
Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the sanding belt.
• Fully unwind cable drum extensions to avoid potential
overheating.
• When an extension cable is required, you must ensure
that it has the right ampere rating for your power tool
and is in safe electrical condition.
• After long working periods external metal parts and
accessories could be hot.
• If possible, always use clamps or a vice to hold your
work.
• Always switch off before you put the sander down.
• Do not force the sander; let the tool do the work at a
reasonable speed. Overloading will occur if too much
pressure is applied and the motor slows resulting in
inefficient sanding and possible damage to the sander
motor.
• When sanding wood, always connect the dust bag or
use a dust extraction system.
• Before using the sander with metal, always remove the
dust bag from the outlet as sparks may ignite the dust
or the bag.
• Do not continue to use worn, torn or heavily clogged
sanding belts.
• Do not touch the moving sanding belt.
• Ensure that you have removed foreign objects such as
nails and screws from the work before commencing
sanding.
• Rags, cloths, cord, string and the like should never be
left around the work area.
• Use safety equipment including safety goggles or shield,
ear protection, dust mask and protective clothing
including safety gloves.
Wear goggles, Wear earmuffs
Wear a breathing mask
The tool must be used only for its prescribed purpose. Any
use other than those mentioned in this Manual will be
considered a case of misuse. The user and not the manu-
facturer shall be liable for any damage or injury resulting
from such cases of misuse.
The manufacturer shall not be liable for any changes
made to the tool nor for any damage resulting from such
changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool’s construction and
design:
• Damage to the lungs if an effective dust mask is not
worn.
• Damage to hearing if effective earmuffs are not worn.
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is
missing. If you find anything wrong, do not operate the
tool until the parts have been replaced or the fault has
been rectified. Failure to do so could result in serious
personal injury.
5