Filter
Top Products
Using the parallel fence guide
The parallel fence allows you to make parallel cuts in a
sheet of wood, all at the same width.
Caution. Always ensure that the saw is switched off and
unplugged from the power supply before making any
adjustments.
1. Slide the parallel fence (9) through the slots in the
base plate.
2. Adjust the guide to the required width and secure it in
position with the locking knob (8).
3. Ensure that the guide rests against the wood along its
entire length to give a consistent parallel cut.
Dust extraction
You can connect the tool to a vacuum system via the dust
extraction port (14).
Changing the blade
Caution. Always ensure that the saw is switched off and
unplugged from the power supply before making any
adjustments.
1. Rotate the saw blade by
hand whilst depressing the
spindle lock button (17)
until the blade locks.
2. Turn the blade bolt anti-clockwise using the hex key
(20) provided.
3. Remove the outer blade flange and the blade bolt.
4. Retract the lower blade guard (11) using
the lever (10).
5. Remove the saw blade from
the inner flange and pull it out.
6. Clean the saw blade flanges
thoroughly before mounting the
new saw blade.
7. Mount the new saw blade in
reverse order and tighten the
blade bolt.
Warning. The direction in
which the blade rotates has to be the same as the
direction of the arrow marked on the housing.
8. Ensure that the spindle lock button (17) is released.
9. Before using the saw again, check that the safety
devices are in good working order.
Important. After replacing the saw blade, make sure that
the saw blade runs freely by turning the blade by hand.
WARNING: Plug the machine in to a power socket and
run the saw under no load to check that it runs smoothly
before using it to cut any material.
10