Filter
Top Products
6
• Avoid cutting nails. Inspect the work piece and remove all
nails and other foreign objects before beginning sawing.
• Support the work properly.
• Never reach over the blade to remove waste or off cuts.
• Do not attempt to free a jammed blade before first
switching off the machine.
• Do not slow or stop a blade with a piece of wood. Let the
blade come to rest naturally.
• If you are interrupted when operating the saw, complete
the process and switch off before looking up.
• Periodically check that all nuts, bolts and other fixings are
properly tightened.
• Always hold the saw on parts that are insulated. If you
accidentally cut into hidden wiring or the saw’s own cable,
the metal parts of the saw will become “live”.
• Never saw near combustible liquids or gases.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to
eliminate all residual risk factors. The following hazards may
arise in connection with the tool’s construction and design:
• Contact with the blade.
• Kickback of work piece and parts of work piece.
• Blade fracture.
• Catapulting of blade pieces.
• Damage to hearing if effective earmuffs are not worn.
• Harmful emissions of sawdust when the machine is
used in closed rooms. Always use supplementary dust
extraction where possible.
• Do not use blades that are deformed or cracked.
• Fully unwind cable drum extensions to avoid
potential overheating.
• When an extension cable is required, you must ensure
that it has the right ampere rating for your power tool and
is in safe electrical condition.
• After long working periods external metal parts and
accessories could be hot.
• Do not force the saw; let the tool do the work at a
reasonable speed. Overloading will occur if too much
pressure is applied and the motor slows resulting in
inefficient cutting and possible damage to the motor.
• Always remove the plug from the mains socket before
making any adjustments or maintenance, including
changing the blade.
WARNINGS. Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on the
nameplate of the tool. A power source with a voltage greater
than that specified for the tool can result in serious injury to
the user, as well as damage to the tool.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful to
the motor.
Wear goggles
Wear earmuffs
Wear a breathing mask
Additional safety rules for the charger
• Before using the charger, read all the instructions and
cautionary markings on the charger and battery pack as
well as the instructions on using the battery pack.
• Only charge your batteries indoors as the charger is
designed for indoor use only.
• DANGER. If the battery pack is cracked or damaged in
any other way, do not insert it in the charger. There is a
danger of electric shock or electrocution.
• WARNING. Do not allow any liquid to come into contact
with the charger. There is a danger of electric shock.
• To allow the battery pack to cool down after charging, do
not place it in a hot environment such as a metal shed or
open trailer left in the sun.