Filter
Top Products
10
Trouble Problem Suggested remedy
Dust collector
will not start
Power cord not plugged in Ensure that the cord is connected to the power supply
Power fault, fuse or circuit
breaker tripped
Check the power supply
Cord damaged Use authorised service centre to repair or replace
Burned out switch Use authorised service centre to repair or replace
Faulty motor Use authorised service centre to repair or replace the motor
Dust collector
suction is poor
Inlet cover is blocked Turn off the dust collector and remove the saw
dust/wood chips blocking the inlet
Outlet cover blocked Turn off the dust collector and remove the saw
dust/wood chips blocking the outlet
Hose blocked Remove any saw dust and wood chips that may be blocked in the
hose. Where the double adaptor is being used remove the plug on
the second 35mm inlet to increase the air flow.
Dust bag is over half full Empty dust bag
Vibration or
abnormal noise
Loose parts Check to see that all screws are secure and tightened
Moving parts excessively worn Use authorised service centre to repair or replace
Trouble shooting
WARNING. Turn the on/off switch to the off position and unplug the tool from the power supply before performing trouble
shooting procedures: