Filter
Top Products
or replaced by an authorised service facility, unless
otherwise indicated in this Instruction Manual.
Defective switches must be replaced by an authorised
service facility. Do not use a tool if the switch does
not turn the tool on and off correctly.
19. Guard against electric shock. Prevent body contact
with grounded objects such as water pipes, radiators,
cookers and refrigerator enclosures.
20. Use only approved parts. When servicing, use only
identical replacement parts. Use an authorised service
facility to fit replacement parts.
Warning. The use of an accessory or attachment, other
than those recommended in this Instruction Manual, may
present a risk of personal injury.
Additional safety rules for sanders.
Warning. Remove the plug from the power socket before
carrying out any adjustment, servicing or maintenance,
including the changing of sandpaper.
• When fitting and changing sandpaper, always follow the
instructions.
• If possible, always use clamps or a vice to hold
your work.
• Make sure that the switch is off before you plug the
tool in.
• Do not over-reach, be sure of your footing and balance
at all times.
• Always wear eye and ear protection and use a dust mask.
• Only use good quality sandpaper.
• Do not force the sander; let the tool do the work at
a reasonable feed speed. Overloading will occur if too
much pressure is applied and the motor slows resulting
in inefficient sanding and possible damage to the
sander motor.
• Always switch off before you put the sander down.
• Disconnect the sander from the power supply when
it is not in use, before cleaning and when changing
sandpaper.
• Rags, cloths, cord, string and the like should never be
left around the work area.
• Do not continue to use worn, torn or heavily clogged
sanding sheets.
• Do not touch the moving sanding sheet.
Ensure that you have removed foreign objects such as
nails and screrws from the work before commencing
sanding.
WARNING. Before connecting a tool to a power source
(mains switch power point receptacle, outlet, etc.) be sure
that the voltage supply is the same as that specified on
the nameplate of the tool. A power source with a voltage
greater than that specified for the tool can result in
serious injury to the user, as well as damage to the tool.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful
to the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who
use and service the machine have to be acquainted with
this Manual and must be informed about its potential
hazards. Children and infirm people must not use this
tool. Children should be supervised at all times if they
are in the area in which the tool is being used. It is
also imperative that you observe the accident prevention
regulations in force in your area. The same applies for
general rules of occupational health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible to
5