Filter
Top Products
14
material and adjust the outfeed fence so that it
supports the cut material, compensating for the
removed stock.
Maintenance
Cleaning
1. Keep the tool’s air vents unclogged and clean at all
times.
2. Remove dust and dirt regularly. Cleaning is best done
with a rag.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
Caution. Do not use cleaning agents to clean the plastic
parts of the router table. A mild detergent on a damp
cloth is recommended. Water must never come into
contact with the router table.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Power cord maintenance
If the supply cord needs replacing, the task must be
carried out by the manufacturer, the manufacturer’s agent,
or an authorised service centre in order to avoid a safety
hazard.