Filter
Top Products
7
Position of tile saw
1. To avoid the possibility
of the appliance plug or
receptacle getting wet,
position tile saw to one
side of a wall mounted
receptacle to prevent
water from dripping onto
the receptacle or plug. The user should arrange a “drip
loop” in the cord connecting the saw to a receptacle.
The “drip loop” is that part of the cord below the level
of the receptacle, or the connector if an extension cord
is used, to prevent water travelling along the cord and
coming in contact with the receptacle.
2. If water is present have an electrician complete any
necessary work or repairs. DO NOT ATTEMPT ANY
REPAIRS YOURSELF.
Accessories
The GMC WTS550 tile cutting saw is supplied with the
following accessories as standard:
• 2 x Mitre blocks
• Bevel plate
• Socket spanner x1
• Face spanner x1
• 200mm Diamond Blade (Fitted)
• 2 x Tile clamps
• Support arms and fixing screws
• Instruction manual
Required tools
A philips head screw driver is required to assemble the
support arms.
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
1. Remove all loose parts from the carton.
2. Remove the packing materials from around the saw.
3. Carefully lift the saw from the carton and place it on a
level work surface.