Graco 1250 Paint Sprayer User Manual


 
Setup
7
Setup
Texture Spraying (material supplied from
unit)
1. Connect air hose and material hose to sprayer air
and material hose outlets.
2. Open air valve.
3. Connect air hose to gun.
4. Connect material hose to gun.
5. Make sure burp guard is installed, Caution, page 3.
6. Install spray nozzle. See Recommended Nozzle
Selection Chart, Page 11.
7. Fill material hopper with 1 gallon of water.
8. Turn hopper gun/spray gun selector switch to
SPRAY GUN.
Important
If you are going to stop spraying for more than 5 minutes, turn sprayer off to prevent shortened pump hose life.
Do not allow material to dry inside pump, hoses, gun or spray system.
When using material
supplied from unit, insert
the Gun Plug in the top of
the gun. Hose plug must
be removed from bottom
of gun.
ti8701a
ti9216a
ti8528a
ti8534a
ti8705a
ti9010a
ti8706a
ti9215a
ti9219a